Cisco 640-816
Interconnecting Cisco Networking Devices Part 2
Version: 11.0
Topic 1, Volume A
QUESTION NO: 1
Refer to the exhibit.
How should the FastEthernet0/1 ports on the 2950 model switches that are shown in the exhibit be configured to allow connectivity between all devices?
A. The ports only need to be connected by a crossover cable.
B. SwitchX (config)# interface fastethernet 0/1
SwitchX (config-if)# switchport mode access
SwitchX (config-if)# switchport access vlan 1
C. SwitchX (config)# interface fastethernet 0/1
SwitchX (config-if)# switchport mode trunk
SwitchX (config-if)# switchport trunk vlan 1
SwitchX (config-if)# switchport trunk vlan 10
SwitchX (config-if)# switchport trunk vlan 20
D. SwitchX(config)# …ver más…

C. RSTP defines no new port states.
D. RSTP is a proprietary implementation of IEEE 802.1D STP.
E. RSTP is compatible with the original IEEE 802.1D STP.
Answer: B,E
Explanation:
QUESTION NO: 7
Refer to exhibit.
Cisco 640-816 Exam
"Pass Any Exam. Any Time." - www.actualtests.com 6
A network administrator cannot establish a Telnet session with the indicated router. What is the cause of this failure?
A. A Level 5 password is not set.
B. An ACL is blocking Telnet access.
C. The vty password is missing.
D. The console password is missing.
Answer: C
Explanation:
QUESTION NO: 8
Cisco 640-816 Exam
"Pass Any Exam. Any Time." - www.actualtests.com 7
A network administrator needs to configure port security on a switch. Which two statements are true? (Choose two.)
A. The network administrator can apply port security to dynamic access ports.
B. The network administrator can apply port security to EtherChannels.
C. When dynamic MAC address learning is enabled on an interface, the switch can learn new addresses, up to the maximum defined.
D. The sticky learning feature allows the addition of dynamically learned addresses to the running configuration. E. The network administrator can configure static secure or sticky secure MAC addresses in the voice VLAN.
Answer: C,D
Explanation:
QUESTION NO: 9
What are two characteristics of a switch that is configured as a VTP client? (Choose two.)
A. If a switch that is configured to operate in client mode cannot