Monografias.com > Física
Descargar Imprimir Comentar Ver trabajos relacionados

Determination of the Photon Fluency using Monte Carlo Simulation



Partes: 1, 2

    1. Abstract
    2. Method

    3. Conclusion

    4. Bibliography

    Abstract

    The Photon Fluency at a point is defined as ratio number
    of photon generated to ones of them arrive to this point. It was
    used to design of local Cobalt-therapy with an additional
    entrance for occupational personnel, reducing slightly the
    distance which should be walked for the radiotherapist or other
    personnel like physicist in medicine or engineer. Mathcad user
    subroutine was implemented for verifying at the proposed design,
    the most critical situation from point of view radiological
    protection using Monte Carlo simulation.

    Introduction

    The treatments with Cobalt require that radiotherapists
    should, who operate the equipment, go in and go out for each beam
    of exposition, because they should change parameters of the
    Gantry, collimator, Table and others. If there is an entrance,
    the Man-hole (MH), near of the Panel of control allow
    them to reduce the distance of walking during their work with the
    equipment, only it is necessary to assurance a good radiological
    protection, such as not to excel absorbed
    dose limits for the occupational personnel.

    Method

    It was elaborated MathCad 13 user subroutine (See Annex
    I) for calculating numbers of photons that initially is randomly
    generated, suffer the first scattering Compton on the wall of the
    local (In case of the Gantry is at 2700) and enter for the MH.
    These photons will hit on the internal wall of the MH.

    A geometrical and probabilistic analysis is carried out.
    This subroutine contains four modules: geometrical data of the
    MH, the First Compton scattering on the wall of the local, the
    Second Compton scattering on the internal wall of the MH, and for
    radiological protection analysis at the entrance of the
    MH.

    We generate a number of photons from de source, they
    will hit with wall of the local, where it may occur three
    processes: scattering Compton, Pair Production and Photoelectric.
    We determine the amount of then can enter across the MH. It is
    used the amount photons, which enter to the MH for simulating the
    interactions on the internal wall of the MH, where the photons
    may suffer the same interactions, like on the wall of the local,
    but with different probabilities.

    For the probabilistic analysis it was taken the water"s
    parameters in all modules (first and second radiation scattered)
    and energy of the photons 1.25 MeV (average energy of 60 Co) and
    0.511 MeV (maximum energy of scattered radiation). We did not
    consider the Rayleigh interaction for this range of energy
    [Bie01]

    We are interested for demonstrating that it will be
    little the amount of photons at the hall, which will deliver an
    equivalent dose lower to the limits for the occupational
    personnel.

    Monografias.com

    Figure No 1 Position and inclination
    angle of the Man-hole. By this way it is not seen from the
    entrance, near of the Panel of control, the zone of reflexion of
    the beam on the wall.

    MODULE OF GEOMETRICAL DATA OF THE MAN-HOLE
    (MH)

    All geometrical data are depicted in Figure
    No. 1.

    When the MH has 900 of inclination, there
    is not escape of photons after scattering on the wall of the
    local

    MODULE OF THE FIRST COMPTON
    SACTTERING

    Here we defined for the Cobalt-60 energy
    (h?=1.25 MeV) the effective atomic number of the concrete of the
    wall of the local for, the probability of the photon-wall,
    Photoelectric, and Compton interactions.

    Monografias.com

    a) Random axes on the wall of the
    local

    Monografias.comMonografias.com

    b) Projection on XZ plane c) Projection
    on YZ plane

    Figure No. 2 The position of the random axes (a),
    concerning to the wall where it is placed the Man-hole, and
    parameters of the first scattering on the wall, and projections
    on XZ and YZ planes, b) and c) respectively.

    For the geometrical analysis it was placed the axes
    coordinate randomly just on one point of area of maximum size of
    the field, where values X and Y are defined (See Figure No. 2) ),
    which will define the angles related to two axes (a11 and a21
    with y axe, and ÃY11 and ÃY21 with
    z). The randomly way are generate the angles a and
    ÃY correspondent to y and z
    respectively, as well as a probability between 0 and 1. Then, if
    the probability is lesser than and equal of occurring Compton
    effect, and the a and ÃY are between a11 and a21, and
    ÃY11 and ÃY21 respectively the photon will enter
    across the Man-hole.

    MODULE OF THE SECOND COMPTON SACTTERING

    a) Random axes on the internal wall of
    the MH

    • b) Projection on the YZ
      plane

    Partes: 1, 2

    Página siguiente 

    Nota al lector: es posible que esta página no contenga todos los componentes del trabajo original (pies de página, avanzadas formulas matemáticas, esquemas o tablas complejas, etc.). Recuerde que para ver el trabajo en su versión original completa, puede descargarlo desde el menú superior.

    Todos los documentos disponibles en este sitio expresan los puntos de vista de sus respectivos autores y no de Monografias.com. El objetivo de Monografias.com es poner el conocimiento a disposición de toda su comunidad. Queda bajo la responsabilidad de cada lector el eventual uso que se le de a esta información. Asimismo, es obligatoria la cita del autor del contenido y de Monografias.com como fuentes de información.

    Categorias
    Newsletter