Nic plus online help user’s guide
July 2003 Document No. CO 004678F – Version 3.2
This document is provided so that you can print specific online help topics. It contains the same information that appears in the unit’s online help file, which is accessed by selecting the HELP tab on the unit’s screen.
15550 Lightwave Drive – Clearwater, Florida 33760 – United States T: 727.442.6677 – F: 727.442.5660 – Toll Free: 800.548.9283 or 877.275.3445 info@lightwave.com – http://www.lightwave.com
Table Of Contents
Introduction ...........................................................................................................1 Version Information …ver más…
Approved cards are:
• • •
Modem: None Flash: SanDisk 48 Mbyte Flash GPIB: National Instruments model number PCMCIA-GPIB.NI-488.2 for Windows NT
10BaseT: RJ45 Connector Panel The NIC Plus connector panel contains a variety of auxiliary interfaces as described below.
Connector 1 10 Gbps RX and TX
Description Optical output and input connectors for OC-192 and STM-64 optical rates. The unit supports the following optical connectors: SC, ST, and FC. Optical output and input connectors for OC-48 and STM-16 optical rates. The unit supports the following optical 3
2
2.5 Gbps RX and TX
NIC PLUS Online Help connectors: SC, ST, and FC. Note: These connectors only appear if the unit is configured with the OC48/STM-16 hardware. 3 4 Trigger In and Out Clock Out SMA connectors used for trigger operation. SMA connector that allows a trigger output for use of optical OC192/STM-64 eye diagram analysis. BNC connectors SONET/SDH electrical rates.
5 6 7
155 Mbps RX and TX
E1/DS1 RX and BNC connectors for E1 and DS1 TX electrical rates. 52/155/622 Mbps RX and TX Optical output and input connectors for OC-1, OC-3, OC-12, STM-0, STM1, and STM-4 optical rates. The unit supports the following optical connectors: SC, ST, and FC.
8 9
E1/DS1 RX and Bantam connectors for DS1 and E1 TX electrical rates. 52 Mbps RX and TX BNC connectors for STS-1 and STM0e signals.
10 E3/DS3 RX and BNC connectors for E3 and DS3 TX